| This controller has been designed for use in radio control aircraft and to support continuous currents of up to 25 amps when using 2-3 cell Li-Po battery packs and up to four sub-micro servos. The ESC features a lightweight plastic case, with exposed, finned heat sinks for both the motor drive mosfets, and unlike many controllers, the BEC regulators give you a more reliable and powerful power supply for your servos.
Features
Up to 25 amps continuous current with proper air flow
Finned heat sinks for both the motor drive mosfets and dual BEC regulators to support up to 4 sub-micro servos
Programmable motor braking
Safe power-arm mode prevents accidental starts
Programmable low voltage cut-off with settings for 2-cell Li-Po (6V), 3-cell Li-Po (9V) or 70% of battery starting voltage
Programmable throttle input range (1.1ms-1.9ms or Auto Select)
Auto motor shut down if signal is lost or there is interference
Programmable timing—2 user selectable ranges for use with a large variety of brushless motors
Pre-wired connectors—E-flite EC3 on battery input and 3.5mm female gold bullets on motor output leads
Soft start
Specifications
Brake: Yes - Programmable
Continuous Maximum Current: 25A
Input Connector Types: 16 AWG with E-flite EC3 Connector
Output Connector Types: 16 AWG with 3.5mm Female Gold Bullet Connectors
Momentary Peak Current: 30A (15 sec)
Dimensions (WxLxH): 28x48x11 mm (1.1x1.9x.4 in)
Weight: 32g (1.2 oz)
Cells w/BEC: 2-3S Li-Po or 6-10 Ni-MH/Ni-Cd
|
