| This controller has been designed for use in radio control aircraft and to support continuous currents of up to 10 amps when using 2-3 cell Li-Po battery packs and up to four submicro servos. Standard features include advance BEC and safe power arming along with programmable features such as low voltage cutoff, braking, timing, and throttle input range.
Features
Up to 10 amps continuous current with proper air flow
Programmable motor braking
Safe power-arm mode prevents accidental starts
Programmable low voltage cut-off with settings for 2-cell Li-Po (6V), 3-cell Li-Po (9V) or 70% of battery starting voltage
Programmable throttle input range (1.1ms-1.9ms or Auto Select)
Auto motor shut down if signal is lost or there is interference
Programmable timing—2 user selectable ranges for use with a large variety of brushless motors
Pre-wired connectors—JST on battery input and 2mm female gold bullets on motor output leads
Soft start
Specifications
Brake: Yes - Programmable
Continuous Maximum Current: 10 Amps
Input Connector Types: 20 AWG with JST Connector
Output Connector Types: 20 AWG with 2mm Female Gold Bullet Connectors
Momentary Peak Current: 12A (15 sec)
Dimensions (WxLxH): 17.5x30x10 mm (.7x1.2x.4 in)
Weight: 10g (.35 oz)
Cells w/BEC: 2-3S Li-Po or 6-10 Ni-MH/Ni-Cd
|
